Honeywell HS331S removal!

Hi to all.

3 years ago I bought a Honeywell HS331S system.

Bought extra sensors etc.

18 months later I installed it.

Instructions were rubbish so spent a lot of time ringing/emailing Honeywell technical.

Their instructions and diagrams they emailed me were nothing like the manual?

Eventually, I got it up and running.

Walk tested etc and everything fine.

A few months later my problems began...

It started randomly chiming from the panel, or just going into full-on siren mode when it wasn't set.

Or when it was set.

Nothing on panel to say any batteries needed replacing.

Sick of hearing it I put it in disarm mode and decided I'd just leave it off and put it down to a waste of money.

Several months ago the panel started chiming or full siren again.

I want to disconnect it and just remove the panel from the wall.

I'll leave the siren box up outside.

How do I remove the control panel so the alarm/box doesn't go off and scare me to death!

Can't find anything on Honeywell or Youtube about removing the system.

Plenty of stuff about installing.

Any help greatly appreciated.

Thanks

I suspect you may of just needed to replace a battery or two and your problem  would have been solved. ? 

To solve you problem you will need to disconnect the battery in the bell-box.

.Thank you for the replies.

There was no indicator lit on the panel to show a low battery.

So it looks like getting the ladders out to get up to the box.

Many thanks again to both of you.

dad1954 said:

So it looks like getting the ladders out to get up to the box.

Click to expand...

Take the wire cutters up with you, (for quick battery disconnection).  And be prepared,  -  the siren WILL sound when you remove the cover.