So if everything is fine at the CU - isolation with no errors, should that be taken as isolation even with the things I had going on in the videos?
Would it make any difference isolating the remote isolation switch?
Cheers.
Locked to prevent being resurrected again
Hello,
Strange yesterdaay. I checked the voltage of a socket and the 400V reading I was getting before was not present today???
I did get some continuity though with N/L. There was some slight lighting of the tester with G and N/L as you can see from the video.
I don't know if it made any...
I am seeing almost all the strips lighting. There are 8 from 12V to 690V. In my case, 7 light up which indicates 400V.
Usually, it should be non of the strips lighting when there is isolation?
I am a DIYer and started the process of fitting a spur from a socket (and from the ring) in a house. A few days ago I converted an old immersion switch into a plug socket. It was linked to the boiler and I had to isolate the boiler after there was continuity with the N/L.
Back to the spur...