Recent content by Nick67GT

Hello to everyone who helped me on this! I have now successfully wired in the switch assembly as follows: Live incoming to terminal 2 of E-switch then out from terminal 1 of E-switch to terminal 23 of on/off switch. Output from terminal 24 of on/off switch to terminal block on back of lathe...

Is there a specific function for A2?

Snake - great feedback - thanks. I can comment as follows: E-stop has 1 NC (terminals 1 -> 2) &1 NO (terminals 3 -> 4) arrangement. As far as the NVR is concerned, I believe that it has an internal link (A1 -> 24) already in place, which is why only 4 terminals are presented for...

Here's a picture of the rear of the switch box. NVR switch with my wiring arrangement.pdf

I'm having trouble uploading a photo of the rear of the switch. But to clarify on how I wired it: Incoming from mains into E-stop terminal 1 & 3. Output from E-stop to terminals 13 (live) and 23 (neutral) then from terminals 14 (live) and 24 (neutral) to terminal block on lathe. The lathe...

Hello all;. This is my first post on the forum, so here goes! I have a small single phase Myford lathe which works fine when hooked up directly to the mains via the manufacturers Live / Neutral terminal block at the rear. It also has a simple inbuilt on / off switch. Since there is almost zero...