Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Main Forums
Do-It-Yourself (DIY) Question & Answer Forum
10Mm Cable Near Hw Pipe
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Talk Electrician Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wellconnected" data-source="post: 392934" data-attributes="member: 26267"><p>i am aware the CPC in the T&amp;E would be inadequate for bonding so if bonding became necessary later by added services the plan would be to run an additional single core 10mm CPC in the 'house section' to ensure the bonding is consistent throughout. Although the SWA armour is of lower rating as a CPC it should be adequate for the intended load (4 fluorescents and a ring for maybe a 2kw heater, computer printer, kettle perhaps and that's about it) I suppose I could use SWA throughout of course from the word go with the added benefit of greater heat tolerance near the pipes. Would that be preferable? There would still be the shower feed though and SWA to that would present termination problems at the bathroom end (can't run straight to shower unit, can't hide a JB under a floor etc and it would be unsightly surface mounted.</p></blockquote><p></p>
[QUOTE="wellconnected, post: 392934, member: 26267"] i am aware the CPC in the T&E would be inadequate for bonding so if bonding became necessary later by added services the plan would be to run an additional single core 10mm CPC in the 'house section' to ensure the bonding is consistent throughout. Although the SWA armour is of lower rating as a CPC it should be adequate for the intended load (4 fluorescents and a ring for maybe a 2kw heater, computer printer, kettle perhaps and that's about it) I suppose I could use SWA throughout of course from the word go with the added benefit of greater heat tolerance near the pipes. Would that be preferable? There would still be the shower feed though and SWA to that would present termination problems at the bathroom end (can't run straight to shower unit, can't hide a JB under a floor etc and it would be unsightly surface mounted. [/QUOTE]
Insert quotes…
Verification
Post reply
Main Forums
Do-It-Yourself (DIY) Question & Answer Forum
10Mm Cable Near Hw Pipe
Top