Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
General Forums
General Chat Area
Conex Push-fit :)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Talk Electrician Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ProDave" data-source="post: 285435" data-attributes="member: 6969"><p>I didn't install it. I was just called to fix it.</p><p></p><p>To make matters worse the bladder in the expansion tank had lost it's air and needed pumping up so the pump was short cycling anyway, adding to the woes for the relay that switched it.</p><p></p><p>As well as advising he needs a new control box for the pump I also pointed out the complete lack of any over pressure relief valve and strongly advised he gets one fitted ASAP.</p><p></p><p>I suspect it was a DIY install by the owner.</p><p></p><p>I didn't think to look at the rating plate for the pressure vessel, but I'll bet it wasn't rated for 13 bar. That would have been VERY nasty if that burst.</p></blockquote><p></p>
[QUOTE="ProDave, post: 285435, member: 6969"] I didn't install it. I was just called to fix it. To make matters worse the bladder in the expansion tank had lost it's air and needed pumping up so the pump was short cycling anyway, adding to the woes for the relay that switched it. As well as advising he needs a new control box for the pump I also pointed out the complete lack of any over pressure relief valve and strongly advised he gets one fitted ASAP. I suspect it was a DIY install by the owner. I didn't think to look at the rating plate for the pressure vessel, but I'll bet it wasn't rated for 13 bar. That would have been VERY nasty if that burst. [/QUOTE]
Insert quotes…
Verification
Post reply
General Forums
General Chat Area
Conex Push-fit :)
Top