Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Main Forums
Do-It-Yourself (DIY) Question & Answer Forum
Disconnecting old Pyro supplied lighting
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Talk Electrician Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="NotBurningthehouse" data-source="post: 498971" data-attributes="member: 32916"><p>Hi, I've searched and searched for information on this topic but can't seem to find any answers on it. I am currently renovating two rooms in my house and I'm looking to include dimmer switches in both however the existing lighting circuits (or 6A radial circuits) of which there are 2 are both run in Pyro/MICC have back boxes that are too small for a dimmer. My plan is to connect to one of these circuits via a new 1.5mm connection that was hooked up for our kitchen about 3 years back as both rooms are already on this same circuit through the pyro. My challenge is that I will want to disconnect the old Pyro runs for each of these, I have found the junction box and located the correct connections however as the the junction box has other connections that will still be in use how can I seal the holes left by the disconnected runs? </p></blockquote><p></p>
[QUOTE="NotBurningthehouse, post: 498971, member: 32916"] Hi, I've searched and searched for information on this topic but can't seem to find any answers on it. I am currently renovating two rooms in my house and I'm looking to include dimmer switches in both however the existing lighting circuits (or 6A radial circuits) of which there are 2 are both run in Pyro/MICC have back boxes that are too small for a dimmer. My plan is to connect to one of these circuits via a new 1.5mm connection that was hooked up for our kitchen about 3 years back as both rooms are already on this same circuit through the pyro. My challenge is that I will want to disconnect the old Pyro runs for each of these, I have found the junction box and located the correct connections however as the the junction box has other connections that will still be in use how can I seal the holes left by the disconnected runs? [/QUOTE]
Insert quotes…
Verification
Post reply
Main Forums
Do-It-Yourself (DIY) Question & Answer Forum
Disconnecting old Pyro supplied lighting
Top