Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Main Forums
Central Heating & Storage Heaters Forum
Ideal Logic Combi Flame Loss problem - advice needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Talk Electrician Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Andy Grow" data-source="post: 476083" data-attributes="member: 31049"><p>Hi!</p><p> My boiler Ideal Logic 30 Combi shows flame loss error (F2 fault).</p><p> Boiler is in the newly property and so far has been used just for hot water, which worked fine.</p><p> The problem appeared when I tried to switch on central heating (The CH system has been drained, flashed and refilled).With "C" on the screen the blue light appears for 3-5 seconds. The boiler buzzes and then goes off and shows F2. </p><p> According to the manual it looks like it's flame detecting electrode fault. But the problem could be with ignition electrode or spark generator and etc. </p><p> I would like to order the parts in advance, before my installer arrives, as he is abroad now. </p><p> When I checked the boiler (there no leaks inside/outside the boiler, condensing pipe is not blocked and clean, condensing trap is clean and filled with clean water) I've found there a hole in a flame detector electrode's silicone sleeve . </p><p> Could this be a main problem? </p><p> As I see the silicone sleeve and electrode being sold separately everywhere. If this is the problem it would be pretty cheap repair, comparing to more expensive parts like gas valve or PCB (also mentioned as possible reasons for fault F2 in a manual). </p><p> Any ideas or advice from the experienced please?</p><p> Thanks in advance!</p></blockquote><p></p>
[QUOTE="Andy Grow, post: 476083, member: 31049"] Hi! My boiler Ideal Logic 30 Combi shows flame loss error (F2 fault). Boiler is in the newly property and so far has been used just for hot water, which worked fine. The problem appeared when I tried to switch on central heating (The CH system has been drained, flashed and refilled).With "C" on the screen the blue light appears for 3-5 seconds. The boiler buzzes and then goes off and shows F2. According to the manual it looks like it's flame detecting electrode fault. But the problem could be with ignition electrode or spark generator and etc. I would like to order the parts in advance, before my installer arrives, as he is abroad now. When I checked the boiler (there no leaks inside/outside the boiler, condensing pipe is not blocked and clean, condensing trap is clean and filled with clean water) I've found there a hole in a flame detector electrode's silicone sleeve . Could this be a main problem? As I see the silicone sleeve and electrode being sold separately everywhere. If this is the problem it would be pretty cheap repair, comparing to more expensive parts like gas valve or PCB (also mentioned as possible reasons for fault F2 in a manual). Any ideas or advice from the experienced please? Thanks in advance! [/QUOTE]
Insert quotes…
Verification
Post reply
Main Forums
Central Heating & Storage Heaters Forum
Ideal Logic Combi Flame Loss problem - advice needed
Top