2 days on the trot that I've been called out as shower is not working.
Both had the same problem---burnt out connector on load side phase(line)terminal.
2nd job was a stinker as piano wire, sorry 6mm t&e, had no slack to reterminate after I had stripped burnt insulation back.
I believe both problems were due to slack terminations caused because there was not enough space to tighten the screw terminals.
Do you all see this regularly and do you advise customer to switch off after use?
Dave2
Both had the same problem---burnt out connector on load side phase(line)terminal.
2nd job was a stinker as piano wire, sorry 6mm t&e, had no slack to reterminate after I had stripped burnt insulation back.
I believe both problems were due to slack terminations caused because there was not enough space to tighten the screw terminals.
Do you all see this regularly and do you advise customer to switch off after use?
Dave2