vad25
Member
- Joined
- Jul 6, 2009
- Messages
- 60
- Reaction score
- 0
Hello every one.
I hope somebody can help me, so as I'm a bit confused about technical data received from client to provide new circuit for sunbed.
It is made in America and 3ph but 230 volts and I can't see Neutral incoming.
Also some instruction from contractor guides:
This unit requires a 230 volts, three phase, 80 amp (4 wire) circuit
actual amp draw of 58 amps
This unit has approximately 5 ft. of # 4 AWG wire (3 hots, 1
ground) coming out of the left side of the back panel
Will be it correct if I install 63 Amp MCB and rotary isolator with same rating or it must be 80 Amp.
Thank you
I hope somebody can help me, so as I'm a bit confused about technical data received from client to provide new circuit for sunbed.
It is made in America and 3ph but 230 volts and I can't see Neutral incoming.
Also some instruction from contractor guides:
This unit requires a 230 volts, three phase, 80 amp (4 wire) circuit
actual amp draw of 58 amps
This unit has approximately 5 ft. of # 4 AWG wire (3 hots, 1
ground) coming out of the left side of the back panel
Will be it correct if I install 63 Amp MCB and rotary isolator with same rating or it must be 80 Amp.
Thank you