I used to have a Kewtech KT61 issued to me by my old employer to replace my separates ( BM223, LT5 ) and it was bloody awful to use when testing Ze on DNO streetlight cutouts if the loop impedance was very low it would just display 0.00 where my old tester would give me a value say 0.05 also I...
Bought one of these on eBay last month and the display is very faint it will just about show the >999 and the analogue arc is even harder to make out.
Would this be an expensive repair and is it worth doing ?
Tester has had new batterys fitted
Yes ive had this before where the existing boiler was replaced Y plan control wiring and a separate cable had to be installed from the boiler to the pump. in the base of the boiler was a removable terminal block kinda like a big black plug with terminals for boiler supply LN pump LN and switch...
When you change a single LNB to a twin/quad the Elevation angle of the dish will need to be raised slightly as the new LNB is heavier and will drag the feed arm down slightly.
There where some FTA satellite kits sold a few years back under the fortec star brand where the LNB needed skewing (...
See some intresting methods on the highways the old favourite seems to be the BS951 clamps wrapped around the armour of the cable, but the other one ive seen is the steel strands twisted together and put into a connector block.
then ive seen a few old install where there is no connection to the...
Ive herd stories in my area of £800 3 bed house rewires apparently they guy floods it with labour and is doing about three a week ! An elederly client was quite proud of the fact the lads doing the council rewires on the estate did his house in two weekends for £750 ! It looked a bloody mess...
Told the guys at Armeg i want a long insulated 4mm terminal driver and a small 2.5mm terminal driver that wont snap the first time i use the thing. Spent far too much money at ELEX but ****** it a bit of retail therapy and where contemplating Coventry in September
Your very welcome ive done the highways for over ten years now ive worked for several local authoritys and contractors. When it comes to highway lighting power suppies ive fitted nearly all the different makes of cutout/isolator units Lucy,Tofco, Charles en direct and the TSS ones you dont see...
My old works van a 57 plate Vivaro had an intresting fault where you could be stopped at the lights waiting to go then when you wanted to move nothing happend unless you revved the balls out of it then it would creep forward slowly until it got going a bit.
Also had the problem with it loosing...
Mine expired in March would have renwed it if i had the money, used to be called a Scats card as i was told and you need it to get onto certain industrial sites. I had to get mine in 2010 when the firm i was working for had a contract relamping the road lighting at stanlow and tranmere oil...